Short answer
Call or email us with a photo and your Warranty ID. We respond within five business days, inspect within fifteen, and fix any defect in how the foam was prepared, mixed, applied or finished at no charge: missed areas, thickness below specification, foam pulling away, or off-ratio foam. Anything you spot at the walkthrough goes on the signed record and is finished before you pay that part.
How FoamGuard handles it
- At the walkthrough: any item still to finish or put right is written on the Completion & Walkthrough Record with a fair value beside it. You may hold back that amount until it's done (Section 6).
- After the crew leaves: A Craftsman's Promise, FoamGuard's 5-year limited craftsmanship warranty, covers loss of adhesion or delamination, voids or missed areas within the agreed coverage, installed thickness below specification, off-ratio or improperly cured foam, and shrinkage or cracking caused by application. We repair, re-spray or replace the affected work with no charge for labor, material, equipment or travel (Section 14).
- Deadlines in writing: a response within five business days and an inspection within fifteen. If a covered defect can't be corrected after a reasonable number of attempts, we refund the part of the price for the affected work.
- The warranty certificate is issued as soon as every payment on the project is recorded; you can check it any time at foam-guard.com/warranty.
- If off-ratio foam ever shows up while we're spraying, we stop, cut out the fresh foam, find the cause, spray test patterns on cardboard until the mix is right, and only then spray your building again.
From the Project Agreement, Sections 6, 14 and 16.
What's typical elsewhere
Two warranties usually apply to spray foam: the manufacturer's product warranty, which normally has to be registered by a certified installer, and the installer's own workmanship warranty. Workmanship warranty length, what it covers and how you make a claim vary from contractor to contractor. Get both in writing, with the length and the claim steps, before you sign.
What the warranty doesn't cover
Damage caused by others, by later trades or alterations, by roof or plumbing leaks, bulk water, structural movement, fire, storm, flood, pests, impact or misuse; failure of the building itself; and normal surface texture and color change of exposed foam. Defects in the foam material itself are covered by the manufacturer's warranty, which we register for you. The full list is in Section 14 of your agreement.
To judge what you're looking at, how to spot bad spray foam shows what good and bad foam look like, and off-ratio spray foam explains the most serious defect.
Want a number for your own project? Price My Project, book a free visit or call (814) 208-3478.
What if we disagree about whether it's a defect?
The agreement sets the steps: we meet you at the property, then FoamGuard has 30 days to inspect and repair or offer a fair remedy in writing, then a neutral mediator if needed (Section 16).
Does the warranty transfer if I sell?
Yes. It stays with the building for the rest of its term when FoamGuard gets written notice within 60 days of the sale.
Is uneven texture a defect?
Natural surface texture and minor variation are normal. Rippled, cracked, shrunken, sticky or discolored foam is not, and is worth a call.
