Short answer

We add foam until the surface meets the thickness on your agreement, or credit you for the shortfall in proportion to the material if you prefer. We spray each surface to average the quoted thickness or up to a quarter inch over, check it with a depth gauge as we go, and show you the readings at the walkthrough. Thickness below specification is also a covered defect under A Craftsman's Promise for five years.

FoamGuard

How FoamGuard handles it

  • We aim at or over the number, never under it. If your quote says 2 inches, each surface should average 2 to 2¼ inches. Hand-sprayed foam has natural texture from point to point, which the agreement treats as normal (Section 2); the average is what we hold ourselves to. Spraying a little extra costs us some material; leaving you short costs your trust.
  • Checked during the spray with a depth gauge pushed into the foam, and the readings go on the Completion & Walkthrough Record. You're welcome to watch the measurements at the walkthrough (Section 2).
  • If a surface averages under it, we add foam there, or credit the shortfall in proportion to the material if you'd rather.
  • Five years of cover: "installed thickness below specification" is one of the defects A Craftsman's Promise covers (Section 14).
  • Up to ¼ inch over is free. You never pay for foam above the quoted thickness.

From the Project Agreement, Sections 2, 6 and 14.

Industry

What's typical elsewhere

Because hand-sprayed foam varies a little from spot to spot, manufacturers' quality-control methods check thickness as the average of several depth-gauge readings over a test area, within a stated tolerance either side of the specified thickness. Ask whether the thickness on a quote is a minimum or an average, how it will be checked, and what happens if it comes up short.

Why a quarter inch matters

On 5,000 square feet of roof deck, a quarter inch is 1,250 board feet of foam, which at $1.50–$2.25 is $1,875–$2,813 of material and labor. It is also R-value: at about R-7 per inch, a typical aged value for HFO closed-cell, a quarter inch is close to R-2. How thick spray foam should be and the thickness versus heat loss test data show what each inch buys.

Want a number for your own project? Price My Project, book a free visit or call (814) 208-3478.

More on this

Can I check the depth myself?

Yes. A thin depth gauge pushed into cured foam reads the thickness in seconds. We show you the readings at the walkthrough, and you can ask for them on any area.

Do I pay for foam that goes over the quoted thickness?

No. Up to a quarter inch over is on us.

Will extra foam affect drywall?

Foam proud of the studs is trimmed flush where a finish goes on.

Sources

  1. Demilec (now Huntsman Building Solutions): Quality Control – Thickness Measurement for HEATLOK spray foam (2007)