Short answer
It shouldn't, because everything near the work is masked first: floors, windows, doors, fixtures and anything parked nearby, plus the gaps in sheathing and around pipes that overspray can travel through. If some gets through, we clean or scrape it off. If a surface can't be cleaned, the Project Agreement says we repair it or pay for it.
How FoamGuard handles it
- Masking: floors, windows, doors, outlets and fixtures near the work, vehicles and equipment that stay in the building, and the HVAC openings in the work area.
- Gaps plugged: gaps in sheathing, around penetrations and between panels are covered before spraying, because in our experience a gap as small as a quarter inch is enough to let overspray through.
- Outdoors: we watch the wind and stop spraying when it is too strong, and keep vehicles away from the building.
- Cleanup: we trim foam where a finish goes on, remove the masking and our debris, and leave the work area broom-clean. That is part of the price.
- If something is damaged: we repair or pay for damage caused by our crew or our overspray (Section 12).
From the Project Agreement, Section 12.
What's typical elsewhere
Industry safety guidance asks installers to write an overspray plan, protect surfaces such as windows, doors and equipment, relocate vehicles, use windscreens in light wind, and not spray foam in winds over about 15 mph; it also tells them to have a plan in place for when overspray damage does occur (ACC Center for the Polyurethanes Industry and SPFA). A quote should say what gets masked, who moves stored items and whether trimming and cleanup are included.
Want a number for your own project? Price My Project, book a free visit or call (814) 208-3478.
Is damage to my car outside covered?
Damage that our work or our overspray causes to your property, inside or out, is ours to repair or pay for.
How is cured foam removed from glass or concrete?
Mechanically: it is scraped or cut off. That is why masking comes first.
Will there be foam dust or trimmings left behind?
No. Trimmings and debris are removed and the work area is left broom-clean.
