Short answer
We don't spray over it. Mold has to be removed and its moisture source fixed first, and the wood has to be dry, because foam sealed over mold covers the problem instead of solving it. If we find mold or wet wood on install day, we stop in that area, show you, and spray it once it has been corrected. You are never charged for extra work you didn't approve in writing.
How FoamGuard handles it
- Mold remediation isn't part of the spray job. It is excluded from the work unless listed on page 1 (Section 2), and it is done by a remediation specialist. We can recommend one and schedule around their work.
- Found on the day: we stop in that area, show you, and put any change on a written change order (Section 8). The rest of the building can usually be sprayed as planned.
- Our moisture check (a thermal camera scan before spraying) is there to catch wet or damp spots before foam covers them.
- Tell us what you know: the agreement asks you to mention known leaks or mold before work begins (Section 10). It changes the plan, not the price for the rest of the job.
- Once it's cleaned and dry, we come back and spray the held-back area.
From the Project Agreement, Sections 2, 8 and 10.
What's typical elsewhere
EPA's homeowner guide says plainly: "Do not paint or caulk moldy surfaces." EPA also says it is not enough to simply kill mold; it must be removed, because dead mold may still cause allergic reactions. The remediation industry's standard, IICRC S520, says physically removing mold contamination is the primary means of remediation, and that "attempts to kill, encapsulate or inhibit instead of proper source removal generally are not adequate."
You will sometimes hear that closed-cell foam "starves" mold by sealing off its air. Closed-cell foam on a clean, dry surface does keep humid air and condensation off the wood from then on. But sealing existing growth in is not an accepted fix: the moisture source that grew it is still there, and if water returns, it grows behind the foam where no one can see it.
The order of work
- Find and fix the moisture source: the roof leak, the plumbing leak, or the air leak carrying humid air to a cold surface.
- Remove the mold (a remediation specialist for anything beyond a small area).
- Dry the wood. Manufacturers' data sheets typically set wood moisture at 19% or less, and the surface has to be free of moisture and anything that would stop the foam from bonding.
- Spray closed-cell foam to keep warm, humid air off the cold surface from then on.
For the background on why foam isn't food for mold, see does spray foam grow mold. In crawl spaces and older homes the same order applies; see crawl space spray foam and spray foam in older homes.
Want a number for your own project? Price My Project, book a free visit or call (814) 208-3478.
Is spraying bleach on it enough?
No. EPA says killing mold is not enough; it has to be removed, because dead mold can still cause allergic reactions.
Will mold delay my whole job?
Usually only the affected area. We spray the rest as scheduled where that makes sense and come back for the held-back area once it is clean and dry.
Does the warranty cover mold?
The workmanship warranty covers how the foam was installed. Damage from roof or plumbing leaks and bulk water is excluded, so fixing leaks first protects the warranty as well as the building.
Sources
- US EPA: A Brief Guide to Mold, Moisture and Your Home
- US EPA: Should I use bleach to clean up mold?
- Restoration & Remediation: "Restorer's Perspective: Are You Still Killing Mold?" quoting IICRC S520 (Maier, 2016)
- Huntsman Building Solutions: HEATLOK HFO High Lift technical data sheet (rev. 11.25.24)
- US EPA: Hidden Mold (archived)
